With your right hand, grasp and turn the whole rear assembly counter clockwise. Grasp the bolt in your left hand and with your left thumb, push in the plunger. Observe the small spring loaded plunger on the rear of the bolt opposite the bolt handle. Separate the firing pin assembly from the bolt body as follows. Then remove the bolt from the rifle and proceed.ī. Swing the safety lever up to the vertical position. If it isn't, put the bolt back in the rifle and close it. It should be in the vertical (upright) position. You may require some help here as this is somewhat difficult (it requires some strength in your hands and you are dealing with a very powerful firing pin spring, so pay careful attention).Ī. To clean the bolt, you must become knowledgeable about its disassembly and reassembly. The preservative grease inside the bolt will cause the rifle to fail to fire.
0 Comments
Leave a Reply. |